Just to be safe measure the area where your door will go too.
Door height and width in cm.
Custom doors can be made to match any size door opening.
As a home improvement contractor the majority of.
General requirements for access recommends that the height of the handle should fall within 900mm and 1100mm above the floor.
This is around waist height for the average adult.
In this post we will show you the standard most common size for both internal bedroom doors and exterior front doors.
Use the smallest figure as your measurement.
On average you can expect to pay roughly 20 25 percent more for a custom door.
Record the height and width of the door frame space.
If for some reason your existing interior door isn t a standard door size don t worry.
The standard height of doors is 2040 mm.
Although custom doors do cost more money.
As the size of the frame you require will depend on the size of the opening there is no standard uk door frame size.
The minimum recommended door width to allow persons with disabilities to pass through is 36 inches.
Entry doors are usually 36 inches wide.
720 mm 770 mm and 870 mm.
Measure the width of the door in 3 locations.
The height for all passage doors must be a minimum of 80 inches and the standard width sizes for interior doors are 24 28 30 32 and 36.
This will help ensure that you select the exact right replacement door.
A lot of new homes are built with higher ceilings and some of the doors are higher than the standard 2340 mm.
In scotland the most common door frame width is 726mm.
Standard door handle height.
Measure the height and width of the framed door space.
The most typical door frame width in england wales is 762mm.
The main difference being an increased door height of 2040mm and door thickness of 40mm.
While a door width of 36 inches is oversized for an interior door it s the standard size for front doors the standard height remains the same however.
Metric sized internal doors are becoming increasingly popular and are most commonly used in scotland and europe.
Regardless of the size of the door the australian standard as 1428 1 design for access and mobility part 1.
The standard door width is 820 mm but there are other popular sizes used.
In australia the standard door size is 2040 x 820 mm x 35 mm.
Door frames can be supplied pre assembled or in component parts which can be cut to size to fit all door sizes.
Metric standard door sizes.
However something to note is that standard door sizes vary depending on which country you are in.
You may also hear this door size being referred to as a 2 9.
2040 x 526 626 726 826 926 x 40mm.